CSR8675 - some question.

wrt503

Hello. Thanks for this forum - a lot of useful information!
I have some question about settings for CSR8675. I have ADK4.2 + PSTool.

Where I can find this setup:
1) How many users can be connected to CSR8675? Where I can find this information? ADK or PSTool?
2) How to clean list of user in CSR8675?
3) Its possible to get information from CSR8675 who is connected? Via SPI? (CSR8675 connected to LCD and print "connected to: "name" " ?


Have a good day!

Regards

wrt503

Thanks a lot.

1) Done, its 8, but maximum? I can find this information in some datasheet?

2) I can see this, number 34; Logical input IDs set to "0" , Vreg turn on, mask 3FFE, button timing "VVLONG". but how it work, how to apply this event? In tab user interfaces/buttons/translation table I see, that logical input ID "0" == PIO 0, same as for Play/Pause. So I need to press "VVLONG" button on PIO 0 , but how to identify how should I need to press button:a) rising?
b) double vs repeat ? not same?? double click = 1x press + 1x press also repeat = 1x press + 1x press?
c) falling?
d) sh single?
e) long rel?
f) vlong rel?
g) vvlong?
h) vvlong rel?
i) tripple = 3x press?

3) Yes, of course it need code. But:
a) can it be done with only CSR8675 + LCD for example some OLED
b) should I use external microprocessor like Arduino with AVR , arduicno connected via i2c / spi ?

Regards

"LED function default can display "Connected" or "Charging" or other"
yes, but I would like to display full name of connected device on display. Something simillar is in new cars "additional feature"